Elhadie, Mohamed and A. N., Mustafizul Karim and A. K. M. , Nurul Amin and Lajis, Mohd Amri (2011) *Development of mathematical cost model for preheated end-milling of AISI D2 tool steel.* In: International Conference on Industrial Engineering and Operations Management, 22-24 January 2011, Kuala Lumpur, Malaysia.

PDF 335Kb |

## Abstract

In this research paper, reliable mathematical model for estimating the cost of preheated end-milling of AISI D2 tool steel using TiAlN coated carbide tool inserts is developed. Initially, the different components of machining cost were identified, followed by establishment of equations to determine their values. Then, the required experimental and non-experimental data were collected and the bottom-up approach was adopted for evaluating the cost of machining corresponding to each of fifteen experimental runs. The Response Surface Methodology (RSM) was used to develop the model in which the cost of machining is given as a function of the machining parameters; cutting speed, feed per tooth, and preheating temperature, and expressed in RM per cm3. ANOVA output was utilized to check the adequacy of the developed model. The developed model was found to be statistically adequate and this was confirmed by the small prediction errors made by the model.

Item Type: | Conference or Workshop Item (Paper) |
---|---|

Uncontrolled Keywords: | machining cost; cost modeling; preheated end-milling; RSM; AISI D2 tool steel |

Subjects: | T Technology > TJ Mechanical engineering and machinery |

Divisions: | Faculty of Mechanical and Manufacturing Engineering > Department of Manufacturing and Industrial Engineering |

ID Code: | 1986 |

Deposited By: | Normajihan Abd. Rahman |

Deposited On: | 05 Oct 2011 10:09 |

Last Modified: | 05 Oct 2011 10:09 |

Repository Staff Only: item control page