Performance of tools design when helical milling on carbon fiber reinforced plastics (CFRP) aluminum (Al) stack

Abdul Rahim, Erween and Mohid, Zazuli and Hamzah, M.R. and Yusuf, A.F. and Rahman, N.A. (2014) Performance of tools design when helical milling on carbon fiber reinforced plastics (CFRP) aluminum (Al) stack. Applied Mechanics and Materials , 465 . pp. 1075-1079. ISSN 1660-7482

[img]PDF
287Kb

Official URL: http://dx.doi.org/10.4028/www.scientific.net/AMM.4...

Abstract

Hole making process is not strictly to the drilling technique where others machining could also influence to the quality in CFRP hole.Therefore, helical milling process becomes as an alternative method to produces bore on CFRP plate thus minimizing the defects. The common defects on CFRP are delamination, splintering and cracking. Meanwhile, if the CFRP stacking together with aluminum plate, burr at exit hole of aluminium plate is produced. Therefore, it is essential to control the critical machining parameters to assure a good quality of the hole. The main objective of this project is to improve the hole quality of CFRPIAL stack in terms of surface roughness using helical milling technique. In addition the cutting force and temperature will be measured as well. There are three levels of cutting speeds; two levels of feed rate and depth per helical path are made accordingly to helical milling characteristics. It was found that all tool design exhibit comparable performance for helical milling process on CFRP/AI stack.

Item Type:Article
Uncontrolled Keywords:aluminum stack; CFRP; helical milling
Subjects:T Technology > TA Engineering (General). Civil engineering (General) > TA401-492 Materials of engineering and construction. Mechanics of materials
Divisions:Faculty of Mechanical and Manufacturing Engineering > Department of Manufacturing and Industrial Engineering
ID Code:5388
Deposited By:Normajihan Abd. Rahman
Deposited On:14 May 2014 08:22
Last Modified:14 May 2014 08:22

Repository Staff Only: item control page