Decision making of screw manufacturing for the best environmental and economic combination by using AHP

Azlan , Mohd Azwir and Buja, Andy Anak and Sia, Chee Kiong and Muhd Nor, Nik Hisyamudin and Azlis-Sani, Jalil (2014) Decision making of screw manufacturing for the best environmental and economic combination by using AHP. Applied Mechanics and Materials , 465 . pp. 1065-1069. ISSN 1660-9336

[img]PDF
352Kb

Official URL: http://dx.doi.org/10.4028/www.scientific.net/AMM.4...

Abstract

This study is an approach to investigate the viable impacts of screw manufacturing. At the same time, choose the suitable material and selected manufacturing process of screw by considering environmental aspects without sacrificing the economic aspect. It is important to the organisation to improve the environmental aspect. Therefore in this study, the decision making was focused on economic aspects to produce the synergy results between economic and environmental impact. The parameters involved were types of material and manufacturing process of screw which using the available data of environmental and production volume. The two different manufacturing approaches being evaluated were machining and forging process. The types of material concerned for forging process encompassed low carbon steel, alloy steel stainless steel, and aluminium alloy. On the other hand, for machining process, the material being considered in screw manufacturing were cast iron, low carbon steel, alloy steel, stainless steel and aluminium alloy. The information of environmental impacts that generated from SolidWorks Sustainability tool and screw production cost were calculate using Manufacturing cost model, both information was used in Analytic Hierarchy Process (AHP) analysis to obtain local priority of economic and environmental impacts. Then, the ranking of both global and local priorities from economic impact and environmental impacts had enabled the determination of appropriate material used for those selected screw manufacturing process. As result, low carbon steel was chosen for forging process whereas cast iron was excelled in machining process, at the same time, stainless steel was not suggested to be used in both two processes.

Item Type:Article
Uncontrolled Keywords:AHP; economic; environment; screw manufacturing; sustainable; viable
Subjects:T Technology > TS Manufactures > TS1-154 Manufactures
Divisions:Faculty of Mechanical and Manufacturing Engineering > Department of Materials Engineering and Design
ID Code:5394
Deposited By:Normajihan Abd. Rahman
Deposited On:11 May 2014 16:00
Last Modified:11 May 2014 16:00

Repository Staff Only: item control page