UTHM Institutional Repository

Prediction of plastic deformation under contact condition by quasi-static and dynamic simulations using explicit finite element analysis

Siswanto, W. A. and Nagentrau, M. and Mohd Tobi, A. L. and Tamin, M. N. (2016) Prediction of plastic deformation under contact condition by quasi-static and dynamic simulations using explicit finite element analysis. Journal of Mechanical Science and Technology, 30 (11). pp. 5093-5101. ISSN 1738-494X

[img]
Preview
PDF
img06161.pdf

Download (13MB)

Abstract

We compared the quasi-static and dynamic simulation responses on elastic-plastic deformation of advanced alloys using Finite element (FE) method with an explicit numerical algorithm. A geometrical model consisting of a cylinder-on-flat surface contact under a normal load and sliding motion was examined. Two aeroengine materials, Ti-6Al-4V and Super CMV (Cr-Mo-V) alloy, were employed in the FE analysis. The FE model was validated by comparative magnitudes of the FE-predicted maximum contact pressure variation along the contact half-width length with the theoretical Hertzian contact solution. Results show that the (compressive) displacement of the initial contact surface steadily increases for the quasi-static load case, but accumulates at an increasing rate to the maximum level for the dynamic loading. However, the relatively higher stiffness and yield strength of the Super CMV alloy resulted in limited deformation and low plastic strain when compared to the Ti-6Al-4V alloy. The accumulated equivalent plastic strain of the material point at the initial contact position was nearly a thousand times higher for the dynamic load case (for example, 6.592 for Ti-6Al-4V, 1.0 kN) when compared to the quasi-static loading (only 0.0072). During the loading step, the von Mises stress increased with a decreasing and increasing rate for the quasi-static and dynamic load case, respectively. A sudden increase in the stress magnitude to the respective peak value was registered due to the additional constraint to overcome the static friction of the mating surfaces during the sliding step.

Item Type: Article
Uncontrolled Keywords: Cylinder-on-flat surface contact; dynamic-explicit; quasi-static; equivalent plastic strain; super CMV; Ti-6Al-4V
Subjects: T Technology > TA Engineering (General). Civil engineering (General) > TA401-492 Materials of engineering and construction. Mechanics of materials
Divisions: Faculty of Mechanical and Manufacturing Engineering > Department of Mechanical Engineering Technology
Depositing User: Mr. Mohammad Shaifulrip Ithnin
Date Deposited: 25 Apr 2017 07:52
Last Modified: 25 Apr 2017 07:52
URI: http://eprints.uthm.edu.my/id/eprint/8657
Statistic Details: View Download Statistic

Actions (login required)

View Item View Item

Downloads

Downloads per month over past year