Items where Division is "Faculty of Engineering Technology > Department of Mechnical Engineering Technology" and Year is 2021

Article

Meng, Choung Chiong and Cheng, Tung Chong and Jo, Han Ng and Syed Mashruk, Syed Mashruk and Fong Chong, William Woei and Samiran, Nor Afzanizam and Guo, Ren Mong and Medina, Agustin Valera (2021) Advancements of combustion technologies in the ammonia-fuelled engines. Energy Conversion and Management, 244. pp. 1-17. ISSN 0196-8904

Book Section

Jum’azulhisham, Abdul Shukor and Muhammad Al-Hapis, Abdul Razak and Azmi, Hassan and Jamian, Rahim (2021) Application of clean agents in fire suppression systems: an overview. In: Progress in Engineering Technology III. Springer, pp. 315-330.

Tajurahim, Nurul Ainina Nadhirah and Mahmood, Salwa and Marsi, Noraini and Raja Mamat, Tengku Nur Azila (2021) Improvement of facilities layout planning related with safety: a case study at quarry. In: Multidisciplinary Engineering Science and Advanced Technology. Penerbit UTHM, UTHM.

Conference or Workshop Item

Ho Chee Leong, Richmond Chris and Zulkipli, Muhammad and Shaari, Muhammad Farid (2021) Design of a low cost coin acceptor for vending machine. In: Progress in Engineering Application and Technology, 22 Jun 2021, UTHM.

Ng, Si Jin and Yong, Tze Mi (2021) Evaluation of high density polyethylene plastic bag performance towards edge and point stresses using taguchi method. In: Progress in Engineering Application and Technology, 22 Jun 2021, UTHM.

Shahedan, Noor Fifinatasha and Abdullah, Mohd Mustafa Al Bakri and Mahmed, Norsuria and Kusbiantoro, Andri (2021) The influence of density, compressive strength and thermal conductivity under variety percentage of glass bubble in geopolymer concrete. In: AIP Conference Proceedings, 5 Mei 2021.

Thesis

Husain, Siti Nor Hawanis (2021) Physical and mechanical properties of cotton waste nonwoven web produced by needle punching method. Masters thesis, Universiti Tun Hussein Onn Malaysia.

Huzaisham, Nur Athirah (2021) The characterization of thermoplastic starch (TPS) reinforced with banana peel (BP) Polymer composites. Masters thesis, Universiti Tun Hussein Onn Malaysia.

Mohammad, Siti Fairus (2021) Samarium strontium cobalt oxide – samarium doped ceria carbonate (SSC-SDCC) as a new potential composite cathode material for low temperature solid oxide fuel cell. Doctoral thesis, Universiti Tun Hussein Onn Malaysia.

Mohd Fodzi, Muhammad Haikal (2021) Municipal solid waste mixed polymer composites based diapers waste (MSWPC-DW) for partition panel. Masters thesis, Universiti Tun Hussein Onn Malaysia.

Muniandy, Nagentrau (2021) Delamination-fretting wear failure evaluation at HAp-Ti-6Al-4V interface of artificial hip implant. Doctoral thesis, Universiti Tun Hussein Onn Malaysia.