Items where Subject is "T Technology > TK Electrical engineering. Electronics Nuclear engineering > TK4001-4102 Applications of electric power"

A

Abdul Azlen, Farah Atiqah (2021) Assessment of electric field on hdpe-natural rubber biocomposite with sphere to sphere electrode configuration. Masters thesis, Universiti Tun Hussein Malaysia.

I

Ibrahim Basheer, Omar Abdelrouf (2022) Designing a large scale solar PV system and impact analysis of its integration into Sudan power grid. Masters thesis, Universiti Tun Hussein Malaysia.

K

K. Ghosh, Bablu and Hasanuzzman, M. and Saad, Ismail and Mohamad, K.A. and Hossain, Mohammad Kamal (2023) Photovoltaic technologies photo-thermal challenges: Thin active layer solar cells significance. Optik, 274. pp. 1-16.

K. Subramaniam, K. Subramaniam and Wan Salim, W. S. I. (2021) Modelling an electrically turbocharged engine and predicting the performance under steady-state engine. International Journal of Automotive and Mechanical Engineering (IJAME), 18 (4). pp. 944-9252. ISSN 2229-8649

M

Mohammed Saffer, Ihsan Salman, Khalid and Salama A. Mostafa, Hayder H. Safi and Ahmad Khalaf, Bashar (2023) Salp swarm and gray wolf optimizer for improving the efficiency of power supply network in radial distribution systems. Journal of Intelligent Systems. pp. 1-12. ISSN 20220221

N

Ng, Chun Keat and Jumadi, Nur Anida (2022) IoT-based instrumentation development for reaction time, kick impact force, and flexibility index measurement. International Journal of Electrical and Electronic Engineering & Telecommunications, 11 (1). pp. 82-87.

Nurhaziqah, A.M.S. and Ahmad, M.K. and Faridah, A.B. and Saputri, D.G. and Ramli, S.A. and Mamat, M.H. and Shimomura, M. (2023) Optimization of polymer blend electrolytes with tuneable conductivity potentials. Materials Letters, 334 (1). pp. 1-4.

R

Roslee, Muhammad Nurrifat and Mohd Muji, Siti Zarina and A Talip, Balkis and Muhammad, Norhayati and Abdullah, Norazlin and Hamdan, Rafidah and Sari, Suhaila (2018) An automatic transfusion set for accelerating inoculation process of agarwood artificial inducer. International Journal of Engineering & Technology, 7 (4.3). pp. 397-402. ISSN 2227-524X

S

Sapit, Azwan and Shather, Saad Kariem and Abed, Farook Nehad (2021) Parameters analysis in wire electrical discharge machine process of titanium alloys with dielectric alumina. Selection and peer-review under responsibility of the scientific committee of the 3rd International Con�ference on Materials Engineering & Science., 42. pp. 1845-1859.

Sithananthan, T. and Bakar, A. A. and Saiman, S. and Poad, H. M. (2024) Design and simulation of DC-DC buck-boost converter with voltage source inverter using MATLAB/Simulink for BLDC Motor Drives. In: POWERING THE FUTURE: INNOVATIONS FOR SUSTAINABLE DEVELOPMENT, ICPEA 2024.

Sulaiman, Dawlat Mustafa and Abdulazeez, Adnan Mohsin and Zebari, Dilovan Asaad and Zeebaree, Diyar Qader and Mostafa, Salama A. and Saleem Sadiq, Shereen (2023) An Attention-Based Deep Regional Learning Model for Enhanced Finger Vein Identification. Traitement du Signal, 39 (6). pp. 1-13. ISSN 1991-2002